Cleanse
1. Creamy Cleanser – Cleanse the area of treatment thoroughly, remove with warm water and pat dry.
2. Dry Skin Relief Bar – Cleanse the area of treatment, allowing the lather to remain on the skin for approximately two minutes. Remove with moisten cotton pads.
Prep
3. Hydrating Toner – Apply with a cotton pad to prep the skin. Allow the skin to dry. This product may sting or tingle on some individuals. Asses sensitivity by asking the patient, “On a scale of one to ten, ten being extremely active, how do you rate this sensation?”
Treat
4. Revitalize: Therapeutic Papaya Mask – Apply a generous amount to the area of treatment using gloved hands. Use the scale of 1-10 to gauge sensitivity. Allow the mask to remain on the skin for up to five minutes. Remove completely with cotton pads moisten with warm water.
5. Sensi Peel®
- Before using, gently agitate the product. Apply the first layer with a cotton pad.
- Use the scale of one to ten to gauge sensitivity. Fan the skin to keep the patient cool between layers. If the patient responds six or higher, do not proceed with another layer. If the patient’s response is between one and five, proceed with another layer.
- Wait until the patient’s sensitivity begins to subside before applying the next layer. The patient will begin to rate lower on the scale of one to ten approximately one to five minutes after each layer is applied.
- The total number of layers is determined by the needs, goals, and individual
sensitivity of the patient. - The maximum number of layers is four.
Correct
6. Customize the protocol with a combination of corrective daily care products to address your patient’s concerns and skincare goals. A suggested combination for targeting sensitive skin is to combine one to two pumps of both Hyaluronic Acid Boosting Serum, Dual Action Redness Relief and a pea-size amount of C&E Advanced and apply to the entire area of treatment.
Retinoid booster (Optional)
7. Add two pumps of Advanced Treatment Booster and a pea-size of Retinol Treatment for Sensitive Skin into gloved hand and gently spread the product over the area of treatment, keeping application even and thin.
- Use the scale of one to ten to gauge sensitivity. Most patients will not have any sensitivity to this product.
- The maximum number of layers is one.
Hydrate and Protect
8. ReBalance and the appropriate PCA SKIN® broad spectrum SPF product – Complete the treatment with this combination to calm, hydrate and protect the skin from UVA and UVB exposure.
9. Hyaluronic Acid Lip Booster – Finish with a liberal application to improve hydration and reduce the appearance of lip lines.
Note: Apply the appropriate PCA SKIN broad spectrum SPF product prior to applying Hyaluronic Acid Lip Booster to protect the lips from UVA and UVB exposure.